Lonza PyroTec PRO Hardware User Manual page 91

Test and
• To ensure operating readiness, perform the following test:
Settings
Please contact your local Lonza representative to schedule a service visit.
Replacement
9.3.1.3 Air LiHa Inline Filter
9.3.1.4
Note: Irrespective of the regular maintenance schedule, the filter needs replaced if mois-
tened because of an erroneous aspiration (too much liquid aspirated).
WARNING
DiTi cone can be contaminated.
Decontaminate the DiTi cone and assure appropriate safety measures.
•
•
WARNING
The filter removal tool can cause injuries.
Avoid piercing your finger or hand.
•
Wear protective rubber gloves during filter removal.
•
To replace the inline filter in the DiTi cone of the Air LiHa, proceed as follows:
• Remove the inline filter from the DiTi cone as shown in the figure below.
PyroTec™ PRO Hardw are User's Manual, V1.2
o Replace the inline filter.
o Instrument Warm-up
Refer to the PyroTec™ PRO Software User Guide.
Filter removal tool
Return to TOC
91
RT-MN024-1.2 02/21