Instrument-Related Hazards And Safety Measures - Lonza PyroTec PRO Hardware User Manual

2.2.1 Instrument-Related Hazards and Safety Measures

Please pay great attention to the following general safety information.
WARNING
• This manual must always be available to all persons performing the tasks described
herein.
• Legal regulations, such as local, state, and federal laws concerning the use or applica-
tion, as well as the handling, of dangerous materials in connection with the PyroTec™
PRO must be strictly followed.
The operating company is responsible for defining instructions in accordance with
•
company procedures and local legal requirements. The instructions provided by the
operating company must be strictly observed.
• Observe the correct environmental conditions for storage and operation.
• Structural changes to the safety devices are forbidden.
Damaged safety devices must be replaced immediately as described in this manual.
•
• The PyroTec™ PRO must not be modified in any way without prior consultation and
written approval from Lonza.
Fire hazard can be caused by the improper use of the PyroTec™ PRO.
•
• The PyroTec™ PRO should not be installed in locations where there is a hazard of ex-
plosion.
Any contamination must be dealt with immediately as described in this manual.
•
• The user is responsible for ensuring that the PyroTec™ PRO is always operated under
proper conditions
• Risk of incorrect measuring results
• Always use recommended consumables and original spare parts for maintenance and
repair to assure good system performance and reliability.
Lifting or moving the instrument can cause serious injuries.
•
• There is potentially lethal voltage inside the instrument.
PyroTec™ PRO Hardw are User's Manual, V1.2
o Authorized modifications to the system may only be performed by an FSE cer-
tified for the repair and upgrading of the PyroTec™ PRO.
o Lonza will reject any claim resulting from unauthorized modifications.
o Maintenance, service, and repair tasks should be performed with care, on
schedule, and only by authorized personnel.
o After system care or maintenance has been performed, operation must only
be resumed after the correct system operating conditions have been verified.
o Injuries to the back due to overload can occur.
o Lifting or moving the instrument must be correctly prepared and may only oc-
cur under the direction of a qualified Lonza person.
o Lifting or moving the instrument can cause damage due to unsecured parts.
Return to TOC
Return to TOC
14
RT-MN024-1.2 02/21