Led Display - Eaton easy800 Manual

3.3 LED display

The following LEDs are provided on the front of the easy800 depending on
device type:
1. POW/RUN
2. NET
3. Config (only easy800-SWD)
4. SWD (only easy800-SWD).
LED POW/RUN
The POW/RUN LED indicates the state of the POW power supply as well as
the RUN or STOP operating mode.
LED off
LED green continuous light
LED green flashing
LED NET (Net)
The NET LED provides information on the status of the Net
(￫ Section "Functionality of the NET faulty", Page 337).
LED off
LED green continuous light
LED green flashing
Config. LED
The Config LED indicates that the project configuration and target
configuration of the device match.
Table 7: Config.-LED (only easy800-SWD)
LED off
LED green continuous light
LED red continuous light
LED SWD (SmartWire-DT)
The SWD LED indicates whether SmartWire-DT is operating error-free.
Table 8: LED SWD (only easy800-SWD)
LED off
LED green continuous light
LED green flashing
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
No supply voltage
STOP operating mode, supply voltage present
RUN operating mode, supply voltage present.
NET not operational, fault in configuration.
Fault! Net is initialized but at least one station has not been detected.
NET operating fault-free
no project configuration present, because e.g.
• Initial Commissioning or
• Program in easy806-SWD was deleted
Target configuration = Project Configuration
Target configuration ≠ Project Configuration
No SWD line present
no supply voltage at POW
no target configuration present
Actual configuration = Target configuration
Actual configuration = Target configuration during addressing
3 Commissioning
3.3 LED display
71