Function Blocks - Eaton easy800 Manual

5 Function blocks

The following description of the function blocks is in alphabetical order.
Each function block is first described in brief. All contacts and coils of the
function block are shown in tabular form. The meaning of the 1 state for the
contact is described, and the function of the coil in the 1 state are described.
Another table uses an example to explain and then describe in detail the
parameters of the function block.
All function blocks have the adjustable basic parameter +/-. It is therefore
described here for all function blocks and only mentioned in brief in the
particular function block descriptions.
The basic parameter +/- is displayed in the first line of the function block
editor. It defines whether the parameter set of the function block can be
called via the PARAMETERS menu during RUN mode. Additional information
on this ￫ section 4.7.4, "PARAMETERS menu", page 132.
Parameters Function
Parameter set can be called via the PARAMETERS menu
+
Parameter set is accessible via PARAMETERS men u
-
The default setting of this parameter is +.
Not all easy800 have all function blocks. Information on this is provided in the
relevant function block description.
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
5 Function blocks
135