Eaton easy800 Manual page 25

800 mounting on a top-hat rail
1
2
Figure 5: easy800 standard
▶ Place the easy800 device diagonally on the upper lip of the top-hat rail.
Press down lightly on both the device and the top-hat rail until the unit
snaps over the lower edge of the top-hat rail.
The easy800 device will clip into place automatically.
▶ Check that the device is seated firmly.
The device is mounted vertically on a top-hat rail in the same way.
800 screw fixing
Fixing brackets that can be inserted on the rear of the easy800 device are
required for screw fixing. The fixing brackets are available as an accessory.
Figure 7: Inserting a fixing bracket
￫
Three fixing brackets are sufficient for a device with four fixing
points.
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
1
2
Figure 6: easy800-SWD
2 Installation
2.1 Mounting 800
21