Eaton easy800 Manual page 359

12.3.6.2 Transistor outputs
The transistor outputs on easy800-SWD can alternatively also be configured
as inputs.
Number of device outputs
Outputs of SWD stations
Power supply of the transistor outputs on
easy800 standard:
Rated operational voltage
permissible range
Residual ripple
Supply current
at signal "0"
at signal "1"
Protection against polarity reversal
Caution!
If voltage is applied to the outputs of easy800 standard when the
polarity of the supply voltage is reversed, this will result in a short-
circuit.
Power supply of the transistor outputs on easy800-SWD:
Potential isolation
from power supply
from the inputs
to the PC interface (COM), memory card,
easyNet, easyLink, AUX
to SWD
Rated operational current at signal "1",
maximum
Lamp load without R
v
Residual current at signal "0" per channel
Max. output voltage
With condition "0" at external load
< 10 MΩ
on 1 signal at
easy800 standard: I = 0.5 A
e
easy800-SWD: I = 0.1 A
e
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
EASY8..-DC-T..., easy800-SWD
easy800 standard: 8 (Q1-Q8)
easy800-SWD: 2 (Q1/Q2)
easy800 standard: none
easy800-SWD: 83 (Q17-Q99)
Ue V DC 24
Ue V DC 20.4 – 28.8
% 5
typ.⁄max. m A 18/32
typ.⁄max. m A 24/44
yes
Corresponds to the DC power supply of
the device (￫ section "12.3.3.2
Voltage supply: DC", page 346)
EASY8...-DC-T...: yes
easy800-SWD: no
EASY8..-DC-T...: yes
easy800-SWD: no
yes
easy800-SWD: no
A easy800 standard: 0.5
Ie
easy800-SWD: 0.1
W easy800 standard: 3 (Q1 – Q4),
5 (Q5 – Q8)
easy800-SWD: 1.2
m A < 0.1
V 2.5
V
easy800 standard: U = U
easy800-SWD: U = U
12 Appendix
12.3 Technical data
-1 V
e
-2 V
e
355