Function Block Inputs (Constants, Operands) - Eaton easy800 Manual

12.9.1 Function block inputs (constants, operands)

Input Meaning of
abbreviation
BF Standard
F1 Factor 1
F2 Factor 2
FO Frequency Operation
FS Frequency Start
HY HYsteresis
I1...I8 Input 1 to Input 8
KP Channel
KP Standard
ME Minimum duty factor
MV Manual Value
NO Numbers Of elements
OS OffSet
PI Standard
PF Standard
PD Period of Duration
RF Standard
SH Setpoint High
SL Setpoint Low
SV Set Value
TC Standard
TG Standard
TN Standard
Tv Standard
X1 X1, interpolation point 1
abscissa
X2 Interpolation point 2
abscissa
Y1 Interpolation point 1
ordinate
Y2 Interpolation point 2
ordinate
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Description
Frequency change in braking phase
Gain factor for I1 (I1 = F1 value)
Gain factor for I2 (I2 = F2 value)
Operating frequency
Start frequency
Switching hysteresis for value I2 (Value HY applies to positive and
negative hysteresis.)
1. to 8. input word
Channel number Value range: 0...7
Proportional gain
Minimum duty factor
Manual manipulated variable
Number of elements
Offset for the value I1
Number of steps in Jog mode
Frequency in jog mode
Period duration
Frequency change in acceleration phase
Upper limit value
Lower limit value
Defined actual value (Preset)
Scan Time
Recovery Time
Derivate action time
Reset time
Lower value of source range
Upper value of source range
Lower value of target range
Upper value of target range
12 Appendix
12.9 Contacts and Coils
377