Eaton easy800 Manual page 379

Contact
Signal smoothing filter
Enable
Get value from NET (GET)
New transferred value present
7-day time switch
Switch on condition fulfilled
Year time switch
Switch on condition fulfilled
Conditional jump
Enable
Fault: No corresponding jump label present or backward jump
Jump Label (LaBel)
Passive jump destination for JC
Value scaling
Enable
Master reset
Activate (trigger)
Set all outputs and markers to zero state
Data multiplexer (easy800 and MFD-CP10...)
Enable
Fault: Incorrect parameter setting, 0 > K > 7
Numerical converter
Enable
Operating hours counter
Enable
Reset
Value overflow (carry)
Set time reached
Pulse output
Enable
Start positioning job
Activate jog mode
Positioning job active
Positioning job active
Fault: Incorrect parameter setting, FO < FS or PF < FS.
Put value on NET (PUT)
Activate (trigger)
Enable active
Pulse width modulation
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Coil Contact
(* = NET-ID 1-8) N/O - N/C
(* = NET-ID 1-8)
FT X EN -
- GT X Q1/GT X Q1
- HW X Q1/HW X Q1
- HY X Q1/HY X Q1
JC X EN -
- JC X E1/JC X E1
LS X EN LS X EN
MR X T_ -
- MR X Q1/MR X Q1
MX X EN -
- MX X E1/MX X E1
NC X EN -
OT X EN -
OT X RE
- OT X CY/OT X CY
OT X Q1/OT X Q1
PO X EN -
PO X S_
PO X TP
PO X BR
- PO X AC/PO X AC
PO X E1/PO X E1
PT X T_ -
- PT X Q1/PT X Q1
12 Appendix
12.9 Contacts and Coils
Number Page
192
X = 01–32
196
X = 01–32
198
X = 01–32
203
X = 01–32
211
X = 01–32
213
214
X = 01–32
218
X = 01–32
220
X = 01–32
223
X = 01–32
227
X = 01–04
228
X = 01 , 02
235
X = 01 - 32
237
375