Table of Contents
Advertisement
EOI Operation
W7B ASD Installation & Operation Manual
7. Stop-Reset Key — Issues the Off command and
decelerates the motor at the programmed rate until
it stops if pressed once while in the Hand mode. If
pressed twice in rapid succession, an Emergency
Off (terminates the ASD output and applies the
brake if so configured) is initiated from the Hand or
Auto modes.
8.
Hand/Auto Key— Toggles the system to and
from the Hand and Auto modes. The Hand LED is
on when the system is in the Hand Command
mode.
The Hand Command mode enables the Command
and Frequency control functions to be carried out
via the EOI.
The Auto mode enables the Command and
Frequency control functions to be carried out via
any one of the following methods:
•
Pulse Input,
•
Motorized Pot (UP/DOWN Frequency),
•
Communication Card,
•
RS232/RS485,
•
Common Serial (TTL),
•
Binary/BCD,
•
LED Keypad,
Figure 18. W7B ASD Panel Indicator Lights and Control.
POWER
White
On when
Power is
applied.
Hand/Off/Auto Switch
26
The input channel selection may be made via
Program EOI Options Hand/Auto Key.
9.
means to access the three root menus. Pressing
the MON/PRG key repeatedly loops the system
through the three root menus (see
32). While looping through the root menus, the
Program menu will display the last menu screen or
sub-menu item being accessed at the time that the
MON/PRG key was pressed.
10.
red while running.
11. Run Key — Issues the Run command while in
the Hand mode. A Run command issued from the
Run Key while in the Auto mode will be stored and
activated once the Hand mode is selected — the
motor will run at the commanded speed.
Front Panel Indicators/Control
RUN
FAULT
Green
Amber
On when
On when
in Run
Fault is
mode.
active.
OFF
HAND
AUTO
Note: Lamp and switch positions are
typeform-specific. See received
drawing for actual positions.
•
Option Card RX2,
•
RX,
•
RR, or
•
VI/II.
MON/PRG Key (Monitor/Program) — Provides a
Run LED — Illuminates green while stopped or
Emergency Stop
terminates the ASD
output and applies a
brake if so configured.
Push to activate-Turn CW to reset.
https://www.toshiba.com/tic/
Figure 24 on pg.
Red
Advertisement
Table of Contents
