Table of Contents
Advertisement
EOI Remote Mounting using the
ASD-MTG-KIT
Note: See Figures
20
and
and the item locations referenced in steps
through 6.
1.
At the EOI mounting location, identify and mark
the locations of the 5.00" by 4.60" hole and the
four 11/32" screw holes.
2.
Cut the 5.00" by 4.60" rectangular hole.
3.
Drill the four 11/32" holes.
CAUTION: Failure to use the correct hardware may result in damage to the outer surface of the EOI panel
and/or improper seating of the panel to the bezel plate. Use caution when mounting the EOI assembly to ensure
that the internal thread clearance is maintained.
Correct
https://www.toshiba.com/tic/
W7B ASD Installation & Operation Manual
21
for the dimensions
1
Figure 20. EOI Bezel Plate Mounting Dimensions.
Figure 21. Screw Length Precaution.
EOI Remote Mounting
4.
Attach and secure the Bezel plate to the front
side of the mounting location using the four 10-
32 hex nuts, 10 split lock washers, and the 10
flat washers.
5.
Attach and secure the EOI to the front side of
the Bezel plate using the four 6-32 x 5/16" pan
head screws, the 6 flat washers, and the 6 split
lock washers.
6.
Connect the RJ-45 extension cable(s).
EOI ASD-MTG-KIT Mounting
Dimensions
Incorrect
29
Advertisement
Table of Contents
