Table of Contents
Advertisement
F288-F292
Direct Access Parameter Information
W7B ASD Installation & Operation Manual
Preset Speed 9
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number 1001 and
is identified as Preset Speed 9. The binary number is applied to S1 – S4
of the Control Terminal Strip to output the Preset Speed (see
additional information on this parameter).
Preset Speed 10
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number 1010 and
is identified as Preset Speed 10. The binary number is applied to S1 –
S4 of the Control Terminal Strip to output the Preset Speed (see
additional information on this parameter).
Preset Speed 11
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number 1011 and
is identified as Preset Speed 11. The binary number is applied to S1 – S4
of the Control Terminal Strip to output the Preset Speed (see
additional information on this parameter).
Preset Speed 12
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number 1100 and
is identified as Preset Speed 12. The binary number is applied to S1 –
S4 of the Control Terminal Strip to output the Preset Speed (see
additional information on this parameter).
Preset Speed 13
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number 1101 and
is identified as Preset Speed 13. The binary number is applied to S1 –
S4 of the Control Terminal Strip to output the Preset Speed (see
additional information on this parameter).
104
Direct Access Number — F288
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
F018
for
Minimum — Lower-Limit (F013)
Maximum — Upper-Limit (F012)
Units — Hz
Direct Access Number — F289
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
F018
for
Minimum — Lower-Limit (F013)
Maximum — Upper-Limit (F012)
Units — Hz
Direct Access Number — F290
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
F018
for
Minimum — Lower-Limit (F013)
Maximum — Upper-Limit (F012)
Units — Hz
Direct Access Number — F291
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
F018
for
Minimum — Lower-Limit (F013)
Maximum — Upper-Limit (F012)
Units — Hz
Direct Access Number — F292
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
F018
for
Minimum — Lower-Limit (F013)
Maximum — Upper-Limit (F012)
Units — Hz
https://www.toshiba.com/tic/
Advertisement
Table of Contents
