Table of Contents
Advertisement
Specifications
W7B ASD Installation & Operation Manual
Cable/Terminal
Specifications
Installation should conform to the latest version of
National Electrical Code (NEC) Article 310
(Conductors for General Wiring, table 310.16 and
310.17), all regulations of the Occupational Safety
and Health Administration, and any other applicable
national, regional, or industry codes and standards.
Note: The following ratings are recommendations
and shall not be the sole determining factor of the
lug or wire size used with the W7B ASD.
196
Application-specific applicables, wire insulation
type, conductor material, and local and regional
regulations are but a few of the considerations
when selecting the actual lug and wire type to be
used with the ASD.
Note: Cable/Terminal specifications are based on
the rated current of the ASD.
Note: Use only 75° C or higher temperature rated
copper wire/cable for motor and power
connections.
Note: Input and Output power wires require
shielding for CE compliance.
https://www.toshiba.com/tic/
Advertisement
Table of Contents
