Table of Contents
Advertisement
Preset Speed 14
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number 1110 and
is identified as Preset Speed 14. The binary number is applied to S1 –
S4 of the Control Terminal Strip to output the Preset Speed (see
additional information on this parameter).
Preset Speed 15
Program Frequency Preset Speeds
This parameter assigns an output frequency to binary number 1111 and
is identified as Preset Speed 15. The binary number is applied to S1 –
S4 of the Control Terminal Strip to output the Preset Speed (see
additional information on this parameter).
https://www.toshiba.com/tic/
Direct Access Parameter Information
W7B ASD Installation & Operation Manual
Direct Access Number — F293
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
F018
for
Minimum — Lower-Limit (F013)
Maximum — Upper-Limit (F012)
Units — Hz
Direct Access Number — F294
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
F018
for
Minimum — Lower-Limit (F013)
Maximum — Upper-Limit (F012)
Units — Hz
F293-F294
105
Advertisement
Table of Contents
