Table of Contents
Advertisement
Optional Analog Terminal Mark
Program Special Special Parameters
Not used.
Current/Voltage Units Setup
Program Utilities Display Parameters
This parameter sets the unit of measurement for current and voltage
values displayed on the EOI.
Settings:
0 — %
1 — V/A
Free Unit Multiplication Factor [0 = off]
Program Utilities Display Parameters
This parameter allows the user to input a quantity to be displayed on the
EOI that is proportional to the output frequency of the drive.
This feature is useful when the output of a process is moved along at a
rate that is proportional to the output frequency of the drive.
Free Unit Selection
Program Utilities Display Parameters
The parameter sets the number of decimal places to be displayed during
non-Accel/Decel functions.
Settings:
0 — 1
1 — 0.1
2 — 0.01
Acceleration/Deceleration Unit Time Setup
Program Utilities Display Parameters
This parameter sets the number of decimal places to be displayed for
Accel/Decel functions.
Settings:
0 — 1
1 — 0.1
2 — 0.01
https://www.toshiba.com/tic/
Direct Access Parameter Information
W7B ASD Installation & Operation Manual
Direct Access Number — F680
Parameter Type — Numerical
Factory Default — 0
Changeable During Run — Yes
Minimum — 0
Maximum — 3
Direct Access Number — F701
Parameter Type — Selection List
Factory Default — %
Changeable During Run — Yes
Direct Access Number — F702
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 200.0
Units — Hz/UDU
Direct Access Number — F703
Parameter Type — Selection List
Factory Default — 0.1
Changeable During Run — Yes
Direct Access Number — F704
Parameter Type — Selection List
Factory Default — 0.1
Changeable During Run — Yes
F680-F704
155
Advertisement
Table of Contents
