Table of Contents
Advertisement
Output Terminal 2 (OUT2) Function
Program Terminal Output Terminals
This parameter sets the functionality of the OUT2 (A and C) output
terminals to any of the possible functions that are listed in
175.
The on and off delay times of the OUT2 terminals may be adjusted to
provide more response time to the device that is connected to the output
terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Output Terminal 3 (FL) Function
Program Terminal Output Terminals
This parameter sets the functionality of the FL output terminals to any of
the possible functions that are listed in
The on and off delay times of the FL terminals may be adjusted to
provide more response time to the device that is connected to the output
terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Output Terminal 4 (OUT3) Function
Program Terminal Output Terminals
This parameter sets the functionality of the OUT4 terminals to any of the
possible functions that are listed in
The on and off delay times of the OUT4 terminals may be adjusted to
provide more response time to the device that is connected to the output
terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
Output Terminal 5 (OUT4) Function
Program Terminal Output Terminals
This parameter sets the functionality of the OUT5 terminals to any of the
possible functions that are listed in
The on and off delay times of the OUT5 terminals may be adjusted to
provide more response time to the device that is connected to the output
terminals.
In addition, the output terminals must be specified as Normally Open or
Normally Closed.
https://www.toshiba.com/tic/
Direct Access Parameter Information
W7B ASD Installation & Operation Manual
Table 8 on pg.
Table 8 on pg.
175.
Table 8 on pg.
175.
Table 8 on pg.
175.
F131-F134
Direct Access Number — F131
Parameter Type — Selection List
Factory Default — RCH (Acc/Dec
Complete)
Changeable During Run — No
Direct Access Number — F132
Parameter Type — Selection List
Factory Default — Fault (All)
Changeable During Run — No
Direct Access Number — F133
Parameter Type — Selection List
Factory Default — LL
Changeable During Run — No
Direct Access Number — F134
Parameter Type — Selection List
Factory Default — UL
Changeable During Run — No
69
Advertisement
Table of Contents
