Cable/Terminal Specifications - Toshiba G7 Quick Start Manual

Cable/Terminal Specifications

Installation should conform to the 2005 National Electrical Code Article 110 (NEC) (Requirements for
Electrical Installations), all regulations of the Occupational Safety and Health Administration, and any
other applicable national, regional, or industry codes and standards.
Note: The following ratings are guidelines and shall not be the sole determining factor of the
lug or wire size used with the ASD. Application-specific applicables, wire insulation type,
conductor material, and local and regional regulations are but a few of the
considerations when selecting the actual lug and wire type to be used with the ASD.
Note: Cable/Terminal specifications are based on the rated current of the ASD and Do Not
include the 10% Service Factor.
For further installation information see the section titled
MCP
Model
Rating
VT130G7U
(Amps)
Recommended
2010B 15
2015B 15
2025B 15
2035B 20
2055B 30
2080B 50
2110B 50
2160B 75
2220B 100
2270B 125
2330B 150
2400B 175
2500B 200
2600B 250
2750B 300
210KB 400
212KB 500
215KB 600
Note: Input and Output power wires require shielding for CE compliance.
Note: (*) Indicates that the item is one of a set of two parallel cables.
G7 ASD Quick Start Guide
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Table 6. 230-volt G7 ASD Cable/Terminal Specifications.
Typical Wire/Cable Size (AWG or kcmil)
Input/Output Power
AM, FM, and II
Maximum
14 10
14 10
14 10
14 10
12 10
10 10
8 4
6 4
4 4
(3-core shield)
3 2
2 2
1/0 2/0
2/0 2/0
*1/0 *4/0
*2/0 *4/0
*4/0 *500
*300 *500
*400 *500
Installation and Connections on pg.
Control Terminals
Terminals
20 18
(2-core shield)
12.
Lug Size Range
Wire-Size/Lug-Capacity for
Input/Output Power
24 to 8
18 to 4
16 to 1
10 to 1/0
12 to 4/0
*(6 to 250)
*(1/0 to 500)
51