Grease Replenishment For Balancer Connection Part - YASKAWA Motoman NX100 Manual

HW0481994
9.2.6

Grease Replenishment for Balancer Connection Part

Exhaust port
Hexagon socket head plug PT1/8
1
Connection Tapered roller bearing
(2 bearings)
Connection
Grease zerk A-PT1/8 (2 grease zerks)
1. Remove the hexagon socket head plugs PT1/8 of connection
28 Balancer Connection Part ".)
2. Inject grease into grease inlets of connection
NOTE The exhaust port is used only for air flow.
Do not inject excessive grease into the gear grease inlet.
3. Reinstall the plugs PT1/8 of connection
torque of 5 N・m (0.51kgf・m). (Apply Three Bond 1211 to the screwed part of the
plug.)
2
2
Connection
1
Grease inlet
Fig. 28 Balancer Connection Part
Grease type: Alvania EP grease 2
Amount of grease: 5 cc
(10 cc for 1st supply)
9-20
9.2 Notes on Maintenance Procedures
Connection
Grease zerk A-PT1/8
1
Exhaust port
Hexagon socket head plug PT1/8
Needle bearing
and using a grease gun.
1 2
and . Tighten the plugs with a tightening
2
Grease inlet
and . (Refer to " Fig.
60/76