Table of Contents
Advertisement
12. CHANGING THE SBS ORIENTATION
The SBS is set up for the desired orientation in the factory already. However it is possible to
reverse the orientation in the field if necessary. This will take approx. 2 hours.
To reverse the orientation, all of the following steps must be performed:
1
.
Reverse the FREE RUNNING CLUTCHES left and right.
2
.
Reposition the CLUTCH ASSEMBLIES left and right.
3
.
Reposition SENSOR B3/4.
4
.
Mount SENSOR B1 to the opposite side.
5
.
Reverse the position of the GUIDE RAIL.
6
.
Route the ADAPTER CABLES to the opposite side.
7
.
Reposition the SERVICE BUTTON.
8
.
Reposition the DFT COVER PLATES.
9
.
DIP SWITCH SETTING.
10.
Reposition the SBS MOUNTING BOLTS.
CLUTCH ASSY with FREE RUNNING CLUTCH
KODAK AG, Stuttgart
SERVICE BUTTON
SENSOR B3
figure 12-1
12-1
II 3066-2
SENSOR B4
SENSOR B1
GUIDE RAIL
10/98
Advertisement
Table of Contents
