Kodak Multiloader 700 Side-by-Side Kit Installation Instructions Manual page 85

19.
Adjust BRACKETS E along the edge of the SBS and to the BACK SERVICE PANEL.
Mount the LONG SIDE PANEL and the PROCESSOR PANEL at the PROCESSOR side.
The drawing shows the installation of the PROCESSOR at the left side.
20.
Apply SILICONE to the back of the BRACKETS A.
21
. Move the SIDE PANELS into the BRACKETS E (see FIGURE 14-7, STEP 1).
22
. Press the SIDE PANELS against BRACKETS A (see FIGURE 14-7, VIEW A,
STEP 2).
23
. Push the SIDE PANELS to the BACK SERVICE PANEL
(see FIGURE 14-7, STEP 3).
24
. Push the BRACKETS G under the SIDE PANELS.
25
. Mount the SIDE PANELS to the BACK SERVICE PANEL using SCREWS 35 mm
long (see FIGURE 14-7, TOPVIEW).
26
. Mount the SIDE PANELS to the BRACKETS A using SCREWS 17 mm long.
KODAK AG, Stuttgart
Mount the SHORT SIDE PANEL at the MULTILOADER side.
NOTE:
14-9
II 3066-2
10/98