Table of Contents
Advertisement
II 3066-2
9
.
Drill the holes for the ANCHORS.
10
. Insert the ANCHORS (261929) into the floor.
11.
Fasten SEISMIC BRACKETS No. 2 with 2 BOLTS (188623) and 2 WASHERS
(173824) each to the floor. NOTE The holes in the SEISMIC BRACKETS are bigger
than the BOLTS to compensate for small errors when drilling the holes into the floor.
12.
Mount all ML700 COVERS.
13.
Carefully move the ML700 into its correct position. Ensure that its levelling feet
slide into the SEISMIC BRACKETS No. 2.
14.
Fasten the ML700 to the SBS.
15.
Fasten SEISMIC BRACKET No. 1 with 2 BOLTS (188623) and 2 WASHERS
(173824) to the floor.
16.
Pull out the ML700 DRAWER and fasten SEISMIC BRACKET No. 3 with 2 BOLTS
(188623) and 2 WASHERS (173824) to the floor. NOTE The single oblong hole in the
vertical part of SEISMIC BRACKET No. 3 fits over the SCREW HEAD of the ML700
TRANSFORMER COVER
17.
Push the ML700 DRAWER back in.
From now on SEISMIC BRACKETS No. 1 and 3 have to be removed, if the ML700 has to be separated
10/98
NOTE
from the system.
15-4
KODAK AG, Stuttgart
Advertisement
Table of Contents
