Table of Contents
Advertisement
4
.
Pull the CONTROL PANEL away from the front of the PROCESSOR.
5
.
From the rear of the CONTROL PANEL, remove and retain the 2 small SCREWS
securing the 200 BOARD.
6
.
Remove and retain the LOCKNUT and WASHER from the PHONO JACK
CONNECTOR.
7
.
Remove the PLATE from the back of the CONTROL PANEL.
8
.
Reassemble the parts removed in STEPS 2 through 6.
9
.
Install the RS 232 CABLE from the SBS to the RS 232 CONNECTOR on the
CONTROL PANEL to check for the proper fit. Check for fit both with and without the
CABLE locked into the STANDOFFS.
SCREW (2)
200 BOARD
PLATE
KODAK AG, Stuttgart
PHONO JACK
figure 7-1
7-3
II 3066-2
CONTROL PANEL
SCREW (4)
WASHER-PHONO JACK
LOCK NUT-PHONO JACK
STANDOFF (2)
10/98
Advertisement
Table of Contents
