Preparation Of The Ml700; Software; Hardware - Kodak Multiloader 700 Side-by-Side Kit Installation Instructions Manual

6. PREPARATION OF THE ML700

SOFTWARE

Only a software version => 4.0 is able to communicate with the SBS. If the ML700 is
equipped with an older version, install the new one now. The new software is part of the
INSTALLATION KIT .
After the new ML700 SOFTWARE is installed, it might be that confusing data are shown on the
ML700 DISPLAY. In this case, move the SERVICE SWITCH on PCB A0 to the right, enter the SERV-
ICE MODE and clear all memories. Exit the SERVICE MODE and press several times the RESET
BUTTON on PCB A0. Then move the SERVICE SWITCH back to the left.

HARDWARE

1
. The TUNNEL CONNECTOR must be relocated. Take out the 2 CONNECTOR
MOUNTING SCREWS and discard them.
TUNNEL CONNECTOR
KODAK AG, Stuttgart
NOTE
CAUTION
TAKE PROPER ESD SAFETY MEASURES.
figure 6-1
6-1
II 3066-2
10/98