Table of Contents
Advertisement
5
.
Adjust the LOWER and UPPER EXIT GUIDE to ensure that the FILM is guided
correctly into the PROCESSOR.
6
.
Insert the CONVEYER into the ADAPTER. There are V-shaped guides on either side
of the CONVEYER FRAME. They guide the CONVEYER into the correct position.
UPPER EXIT GUIDE
V-shaped GUIDE
7
.
Route the cable out of the ADAPTER. The SENSOR - and MOTOR WIRES will be
connected later to PCB A4.
8
.
Fix the CONVEYER in place with 2 MOUNTING SCREWS. Use SCREWS M4x10.
9
.
Set up the PROCESSOR as required. See the PROCESSOR INSTALLATION
MANUAL.
KODAK AG, Stuttgart
figure 13-5
SCREWS M4x10
figure 13-6
13-3
MOUNTING SCREW (3)
LOWER EXIT
GUIDE
II 3066-2
10/98
Advertisement
Table of Contents
