Kodak Multiloader 700 Side-by-Side Kit Installation Instructions Manual page 14

II 3066-2
3
. Mount the ADAPTER FRAME to the rear of the PROCESSOR. Use the existing 2
bottom screws only. These SCREWS are packed with the PROCESSOR INSTALLATION
KIT.
The PROCESSOR SCREWS are UNC thread, the SBS and ML700 SCREWS are metric.
4
. Mount the FILM GUIDE and fix it with 3 SCREWS (UNC). These SCREWS are
packed with the PROCESSOR INSTALLATION KIT. If necessary add WASHERS from
the PROCESSOR INSTALLATION KIT.
10/98
NOTE
MOUNTING SCREW
figure 2-3
figure 2-4
2-2
MOUNTING SCREW
FILM GUIDE
KODAK AG, Stuttgart