II 3066-2
1
.
Insert the PLASTIC BEARING into the BRACKET. Use the right-hand hole.
2
.
Feed the MAIN SWITCH EXTENSION from underneath through the PLASTIC
BEARING.
3
.
Screw the KNOB onto the MAIN SWITCH EXTENSION.
4
.
Slide the ACTUATOR on the short arm of the MAIN SWITCH EXTENSION.
5
.
Secure the ACTUATOR with 1 C-RING at the indicated C-RING POSITION, that it
cannot slide off.
6
.
Engage the ACTUATOR with the horizontal part of the PROCESSOR MAIN SWITCH.
7
.
Gently pull up the KNOB to test if the MAIN SWITCH is actuated.
8
.
Gently press down the KNOB to switch off the PROCESSOR MAIN SWITCH.
10/98
7-8
KODAK AG, Stuttgart