Processor Set-Up; 460/480Ra Processor - Kodak Multiloader 700 Side-by-Side Kit Installation Instructions Manual

7. PROCESSOR SET-UP

CHECK THAT THERE IS REALLY 120 VAC AT THE SAFE LIGHT RECEPTACLE.

460/480RA PROCESSOR

The SAFE LIGHT RECEPTACLE must provide 120 VAC as long as the PROCESSOR is
switched on. This can be selected via the PROCESSOR OPERATOR KEYBOARD.
The 460/480 CONTROL PANEL/DISPLAY should be actuated as follows in order to be certain that the "AC-
1
. Press "GO TO SETUP" when the 480 DISPLAY shows "READY" in the upper left
corner. The DISPLAY will then show:
PROCESSOR NOT READY
ENTER ACCESS CODE OR CANCEL REQUEST
1
2
. Enter the ACCESS CODE 4-2-1-3. The DISPLAY will show:
PROCESSOR NOT READY
PRESS BUTTON TO SELECT
CYCLE PROC-
3
. Press "OPTIONS". The DISPLAY will show:
PROCESSOR NOT READY
PRESS BUTTON TO SELECT
REPLEN TEMP
MODE
KODAK AG, Stuttgart
CESSORY MODE" is used.
2 3 4
SETUP
OPT. LANG
ESS
DISPLAY MORE
LOCK UNITS
CAUTION
NOTE
CANCEL
REQUEST
DONE/
RETURN
DONE/
RETURN
7-1
II 3066-2
10/98