Table of Contents
Advertisement
II 3066-2
REVERSE THE FREE RUNNING CLUTCHES
1
.
Push the complete assembly in and hold it. Take out the C-RING.
2
.
Slide out the SHAFT until the GEAR with the FREE RUNNING CLUTCH comes free.
3
.
Reverse the GEAR.
4
.
Slide in the SHAFT and secure it with the C-RING.
5
.
Check on the ML700 side that the CLUTCH is engaged when the FILM is transported
into the SBS CARRIAGE.
6
.
Check on the PROCESSOR side that the CLUTCH is engaged when the FILM is
transported out of the SBS CARRIAGE.
7
.
Check that correct rotation of the clutches is achieved. Manually rotate MOTOR M2.
If the CARRIAGE is on the ML700 side the BELTS must transport the FILM away from
the ML700. If the CARRIAGE is on the PROCESSOR side, the BELTS must transport
the FILM to the PROCESSOR.
C-RING
10/98
The procedure for the CLUTCH left and right is the same.
NOTE
GEAR WITH FREE RUNNING CLUTCH
KEY
figure 12-2
12-2
SHAFT
KODAK AG, Stuttgart
Advertisement
Table of Contents
