Table of Contents
Advertisement
REPOSITION THE CLUTCH ASSEMBLY LEFT AND RIGHT
1
.
Select the new position for the CLUTCH ASSEMBLIES on either side.
There are LABELS with the various positions marked. See figure 12-5.
REPOSITION SENSOR B3/4
1
.
Select the new position of SENSOR B3/4.
There are LABELS with the various positions marked. See figure 12-5.
2
.
The final position of SENSOR B3/4 must be adjusted after the complete system is set
up. See Chapter 11.
MOUNT SENSOR B1 TO THE OPPOSITE SIDE
1
.
Mount SENSOR B1 to the opposite side.
2
.
Check after SYSTEM SET UP the gain adjustment of this SENSOR.
Turn its GAIN ADJUSTMENT SCREW ccw until the INDICATOR LED turns red.
Turn the SCREW cw until the INDICATOR LED turns green.
Turn 1 step further. Not more !!! This would cause the SENSOR to ignore the FILM.
REVERSE THE POSITION OF THE GUIDE RAIL.
1
.
Select the new position of the GUIDE RAIL.
There are LABELS with the various positions marked. See figure 12-5.
ROUTE THE ADAPTER CABLES TO THE OPPOSITE SIDE
1
.
Open the CABLE DUCT and route the CABLES for the PROCESSOR ADAPTER to
the other side.
2
.
If the PROCESSOR has to be right of the ML700 an EXTENTION CABLE (PN
9261311) is required. Connect it to PCB A4X15 and route it to the PROCESSOR side.
3
.
Fix the CABLES with WIRE TIES and close the CABLE DUCT.
KODAK AG, Stuttgart
NOTE
NOTE
NOTE
This SENSOR must be at the ML700 exit
NOTE
12-3
II 3066-2
10/98
Advertisement
Table of Contents
