Table of Contents
Advertisement
Changing to 50 Hz Operation
[1]
Loosen the 2 SCREWS and remove the drive
SIDE PANEL.
[2]
Remove the 2 GUARD SCREWS and the
CHAIN GUARD.
[3]
Loosen the 4 MOUNTING SCREWS.
[4]
Remove the DRIVE CHAIN.
[5]
Loosen the SETSCREW.
[6]
Remove the existing 16-TOOTH SPROCKET
from the MOTOR SHAFT.
[7]
Install the new 50 Hz 19-TOOTH SPROCKET
on the MOTOR SHAFT.
[8]
Tighten the SETSCREW.
[9]
Install the DRIVE CHAIN.
DRIVE CHAIN
SETSCREW
CHAIN
GUARD
981159
GUARD
SCREW (2)
[10]
Check that the DRIVE CHAIN does not touch
the MOUNTING PLATE.
Do not overtighten the MOUNTING
SCREWS. Tighten only until the
RUBBER ISOLATORS, not shown, on
the MOUNTING SCREWS are partially
seated.
[11]
Tighten the 4 MOUNTING SCREWS.
[12]
Install the CHAIN GUARD and the 2 GUARD
SCREWS.
[13]
Install the SIDE PANEL.
MOUNTING PLATE
16-TOOTH SPROCKET
MOTOR SHAFT
MOUNTING SCREWS (4)
SCREW (2)
SIDE
PANEL
H112_0149DCA
H112_0149DA
11
Advertisement
Table of Contents
