Table of Contents
Advertisement
5
.
Insert the CONVEYER into the ADAPTER. There are V-shaped guides on either side
of the CONVEYER FRAME. They guide the CONVEYER into the correct position.
6
.
Route the cable out of the ADAPTER. The SENSOR - and MOTOR WIRES will be
connected later to PCB A4.
7
.
Fix the CONVEYER in place with 2 MOUNTING SCREWS. Use SCREWS M4x10.
KODAK AG, Stuttgart
V-shaped GUIDE
figure 2-5
SCREWS M4 x 10
figure 2-6
2-3
II 3066-2
10/98
Advertisement
Table of Contents
