Table of Contents
Advertisement
7
.
Place the TEMPLATE (scale 1:1) on the floor. Ensure that its marks for the front
corners line up with the marks made in step 4 and 5. Fasten the TEMPLATE with tape
to the floor.
SEISMIC BRACKET No. 1
SEISMIC BRACKET No. 2 is used two places. The single oblong hole in the vertical part of SEISMIC
BRACKET No. 3 fits over the SCREW HEAD of the ML700 TRANSFORMER COVER.
8
.
Mark the bore holes for the 4 SEISMIC BRACKETS on the floor and remove the
template.
KODAK AG, Stuttgart
SEISMIC BRACKET No. 2
FRONT LEFT
SEISMIC BRACKET No. 2
TEMPLATE
SEISMIC BRACKET No. 3
figure 15-2
NOTE
15-3
FRONT RIGHT
II 3066-2
10/98
Advertisement
Table of Contents
