4. User Mode
Entering the User Mode
Changing the Parameters
Exiting the User Mode
Parameters
06/2009
The User Mode allows you to select the settings to be used for the different
pre-set modes. It also allows you to validate specific local requirements for
some countries.
1. Turn on the system.
The self-test is activated. At the end of the self-test, the software
information is displayed (for example, F718 1.00).
2. Quickly press the selection knob on the control timer to enter the menu.
You have access to the menu, when "USER" is displayed. The display
intermittently shows the first parameter (P 03) and the setting (for
example, "0").
3. To change from one parameter to another, turn the selection knob step
by step in any direction.
To change the parameters:
1. Press and hold the selection knob at least 3 seconds until the display
shows "EDIT" and you hear a sound.
The parameter value starts blinking.
2. Turn the selection knob to change the parameter value.
•
To validate your choice, press and hold the selection knob at least 3
seconds until "COPY" is displayed and a noise sounds.
•
To keep the initial value, press the selection knob briefly until "Abor"
is displayed. The system returns to the parameters/programs mode.
To exit the User mode, press the selection knob briefly.
"Quit" is displayed before the system returns to the operational mode.
N°
Parameters
P 03
Country of installation
P 4.1
Film mode setting
P 4.2
Digital mode setting
P 05
Tube seasoning procedure
P 06
Show mode
Table 2: Parameters for User Mode
SM731_K2200_01_en
Choice
0 for all countries except those
having specific local
requirements. Refer to
Installation Manual
S 01 to S 16
S 01 to S 16
Changes OFF to ON. Refer to
Installation Manual
ON to disable X-ray emission
OFF (default) to enable X-ray
emission
4-1