Table of Contents
Advertisement
II 3066-2
3
.
Take out the CONNECTOR for the AUX/RUN CABLE ASSEMBLY at the rear of the
M6B. Store the harness with CONNECTOR inside the M6B and ensure that it does not
come into conflict with moving parts.
4
.
Mount the ADAPTER FRAME to the rear of the PROCESSOR. Use the existing 2
bottom screws only. If necessary add WASHERS from the PROCESSOR
INSTALLATION KIT.
The PROCESSOR SCREWS are UNC, the SBS and ML700 SCREWS are metric.
10/98
AUX/RUN CONNECTOR
figure 3-3
NOTE
MOUNTING SCREW
figure 3-4
3-2
KODAK AG, Stuttgart
Advertisement
Table of Contents
