Table of Contents
Advertisement
5
.
Take out both TUNNEL MOUNTING BOLTS (left and right) and discard them.
6
.
MOUNT the SBS-PLATE to the ML700 (use ALLEN HEAD SCREWS M4x16 from the
SBS INSTALLATION KIT). It is not necessary to take off the TUNNEL HOOK (see
figure above), just move it down when you mount the SBS-PLATE. Ensure that the new
ADAPTER CABLE is located within the little CABLE DUCT of the SBS-PLATE.
There must be a SPACER on either side between plate and ML700.
SPACER
CABLE DUCT
KODAK AG, Stuttgart
TUNNEL SAFETY HOOK
figure 6-4
NOTE
ADAPTER CABLE SHORT
figure 6-5
6-3
TUNNEL MOUNTING BOLT
SBS-PLATE
MOUNTING
SCREW
II 3066-2
10/98
Advertisement
Table of Contents
