Parking Brake Lever; Engine Cut-Off Switch - BRP Lynx REV-XU Series Operator's Manual

mmo2014-004-001_a
TYPICAL
1. Brake lever
2. To apply brake

4) Parking Brake Lever

Parking brake lever is located on the LH
side of handlebar.
Parking brake should be used when-
ever snowmobile is parked.
mmo2014-004-001_b
TYPICAL
1. Parking brake lever
WARNING
Make sure parking brake is fully
disengaged before operating the
snowmobile. When you ride the
vehicle, brake pads that are caused
to drag by a continuous pressure
on the lever may cause damage to
the brake system and cause loss of
braking capacity and/or fire.
To Engage Parking Brake
Apply and hold brake, then lock brake
lever using the parking brake lever as
shown.
CONTROLS, INSTRUMENTS AND EQUIPMENT
mmo2009-005-006_a
TYPICAL — ENGAGE MECHANISM
Step 1: Apply and hold regular brake
Step 2: Lock brake lever using parking brake
lever
To Release Parking Brake
Squeeze brake lever. Parking brake
lever will automatically return to its
original position. Always release park-
ing brake before riding.

5) Engine Cut-Off Switch

The engine cut-off switch is located to
on the LH side of console.
The tether cord cap must be securely
snapped to the engine cut-off switch
to allow vehicle operation.
NOTE: After engine starting, 2 short
beeps should be heard if a pro-
grammed D.E.S.S. key (tether cord
cap) is correctly snapped on engine
cut-off switch. If another beep code
is heard, refer to
TEM
for D.E.S.S. malfunction codes
information.
Always attach the tether cord eye-
let to clothing before starting the
engine.
Pulling the tether cord cap from the
engine cut-off switch shuts the engine
off.
_______________
MONITORING SYS-
WARNING
45