Hood; Upper Side Panels - BRP Lynx REV-XU Series Operator's Manual

CONTROLS, INSTRUMENTS AND EQUIPMENT

27) Hood

WARNING
Never operate engine with hood
removed from vehicle.
Hood Removal
1. Remove upper side panels as ex-
plained below.
2. Unhook the rubber ties on both
sides.
mmo2009-004-038_a
1. Rubber tie
3. Slide hood towards front to free the
tabs from their slots.
Hood Installation
1. Engage the tabs located at front and
center of the hood into the bottom
pan slots.
mmo2009-004-039_a
TYPICAL
1. Tabs
2. Slots
2. Slide hood towards headlights until
it stops.
______________
68
3. Hook the rubber ties.

28) Upper Side Panels

WARNING
Never operate engine with side
panels opened or removed from
vehicle.
Upper Side Panel Removal
1. Unhook the rubber tie.
mmo2009-004-040_a
1. Rubber tie
2. Lift the rear portion of panel to free
the plastic tab from the console.
3. Slide panel towards rear.
Upper Side Panel Installation
1. Insert the panel lower tabs into the
bottom pan slots.
mmo2009-004-042_a
1. Panel lower tabs
2. Bottom pan slots