BRP Lynx REV-XU Series Operator's Manual page 109

MAINTENANCE PROCEDURES
NOTICE
Engine oil and oil filter
must be replaced at the same time.
1. Bring engine to its normal operating
temperature.
2. Place vehicle on a level surface.
3. Remove the LH side panel.
4. Remove the drive belt guard. Re-
CONTROLS, INSTRUMENTS
fer to
AND EQUIPMENT
5. Remove dipstick.
mmr2009-111-100_b
LH SIDE OF VEHICLE
1. Oil tank dipstick
OIL FILTER
6. Remove
in this subsection.
7. From underneath vehicle, clean
drain plug area and remove plas-
tic cap.
fmo2016-006-013_a
1. Frame opening to reach drain plug
8. Place a drain pan under frame open-
ing.
9. Remove engine oil drain plug and
discard sealing washer.
______________
106
section.
, see procedure
10. Allow oil to drain completely.
11. Install NEW sealing washer and
O-ring on oil drain plug.
NOTICE
Never
washer a second time. Always re-
place with a new one.
mmr2009-111-005_a
1. Sealing washer
2. O-ring
3. Oil drain plug
12. Install drain plug and tighten to
specification.
TIGHTENING TORQUE
Drain plug
13. Install a new
cedure in this subsection.
14. Refill oil tank at the proper level
with the recommended oil.
APPROXIMATE ENGINE OIL
CAPACITY (WITH FILTER)
3.5 L (3.7 qt (U.S. liq.))
15. Reinstall dipstick in oil tank.
16. Start engine and let it idle for a few
minutes.
17. Ensure there are no leaks.
18. Stop engine and check oil level as
explained in this subsection. Refill
as necessary.
19. Dispose oil and filter as per your lo-
cal environmental regulations.
use a sealing
30 N•m (22 lbf•ft)
OIL FILTER
, see pro-