BRP Lynx REV-XU Series Operator's Manual page 16

– Meadows sometimes have low areas where water accumulate and freezes
over in winter. This ice is usually glare ice. Attempting to turn or brake on
this surface could cause your vehicle to spin out of control. Never brake or
attempt speeding or turning on glare ice. If you do happen to travel over such a
condition, reduce speed by carefully releasing the throttle.
– Never "jump" with your snowmobile.
– When riding in a group, do not "gun" the throttle. Snow and ice can be thrown
back into the path of a following snowmobile. In addition, when "gunning" the
throttle, the vehicle digs into and leaves an irregular snow surface for others.
– Riding in a group is both fun and enjoyable but don't show off or overtake others
in the group. A less experienced operator might try to do the same as you and
fail. When riding with others, limit your abilities to the experience of others.
– In case of an emergency, press down on the emergency engine stop switch,
then apply brakes.
– Never run the engine in a non-ventilated area and/or if vehicle is left unattended.
– Always engage parking brake before starting the engine.
– Never charge or boost a battery while installed on snowmobile.
– E-TEC engines: Never attempt any fuel system or electrical system main-
tenance or repair. Any maintenance or repair of these systems must by
performed by an authorized Lynx dealer.
– Ensure the path behind is clear of obstacles or bystanders before proceeding in
reverse.
– Always remove the tether cord cap from engine cut-off switch when vehicle is
not in operation in order to prevent accidental engine starting, to avoid unautho-
rized use by children or others or theft.
– NEVER stand behind or near a rotating track. Debris could be projected causing
severe injuries. To remove packed snow or ice, stop engine, tilt and hold vehicle
on its side and use screwdriver from tool kit.
– You may stud the track on this vehicle model. However, you MUST only use the
BRP approved type stud for use on Lynx snowmobiles. DO NOT EVER use con-
ventional studs, the track thickness is thinner compared to some other tracks.
The stud could tear off track and be projected.
– Never ride as a passenger unless the snowmobile is equipped with a passenger
seat and passenger handholds or holding strap. Sit only on the designated pas-
senger seat.
– Always wear an approved helmet and follow the same dressing guidelines as
those recommended for the operator and described in this guide.
– Make sure that you are able to achieve a stable stance, both feet resting posi-
tively on the footboards of footrests with good grip, and that you are able to hold
on firmly to the handholds.
– Once underway, if you feel uncomfortable or insecure for any reason, don't
wait, tell the driver to slow down or stop.
________
SAFETY INFORMATION
SPECIAL SAFETY MESSAGES
________
13