Preseason Preparation - BRP Lynx REV-XU Series Operator's Manual

PRESEASON PREPARATION

Inspect engine rubber mounts
Check exhaust system condition and check for leaks
Tighten exhaust manifold screws or nuts to specified torque
ENGINE
Inspect cooling system cap, hoses and clamps and check for leaks
Check coolant density
Inspect crankshaft PTO seal
Inspect fuel lines and connections
FUEL
SYSTEM
Inspect throttle cable
Inspect drive belt (adjust at every drive belt replacement)
Clean and visually inspect drive pulley
Clean and inspect driven pulley
Inspect, adjust and align track
DRIVE
Adjust drive chain (Not for models equipped with gearbox)
SYSTEM AND
BRAKE
Change chaincase / gearbox oil
Change NEW gasket ring with gearbox oil change. Apply LOCTITE 542
on the thread of the plug (XU models)
Check brake fluid level
Inspect brake hose, pads and disk
Inspect steering mechanism
STEERING
SYSTEM
Inspect skis and runners
Inspect front suspension
SUSPENSION
Inspect rear suspension (including stopper straps and slider shoes)
Inspect spark plugs (All except E-TEC)
Replace spark plugs after starting the engine with the old spark plugs
ELECTRICAL
to burn the excess of storage oil (550 model)
SYSTEM
Charge battery (if so equipped)
Adjust headlight beam aiming
______________
128
PRESEASON PREPARATION (2-STROKE)