Brake Lever - BRP Lynx REV-XU Series Operator's Manual

CONTROLS, INSTRUMENTS AND EQUIPMENT
WARNING
Test the throttle lever operation
each time before starting the en-
gine. The lever must return to its
the rest position once released.
Otherwise, do not start engine.
Switching from Thumb to Finger
Throttle Position
CAUTION It is highly recom-
mended to immobilize the snowmo-
bile before attempting any modifi-
cation to the throttle position as it
could lead to a hazardous situation.
There are mainly three positions to
choose from when going from the
thumb to the finger throttle position
and the best one will be to the rider's
preference and in direct relation with
the riding style and conditions.
mmo2015-008-102_a
THUMB THROTTLE POSITION : PUSH
DOWNWARD TO ROTATE THROTTLE
HOUSING
______________
44
mmo2015-008-100_a
IF WANTED, CONTINUE TO ROTATE THE
THROTTLE HOUSING
mmo2015-008-101
FINGER THROTTLE POSITION
CAUTION
– It is HIGHLY recommended to use
gloves and NOT mitts when using
the finger throttle position.
– It is not recommended to use the
finger throttle position while rid-
ing in dense off trail areas.
The procedure to go back to the thumb
throttle position is the reverse of the
one shown above.

3) Brake Lever

Brake lever is located on the LH side of
handlebar.
When squeezed, the brake is applied.
When released, it automatically re-
turns to its the rest position. Braking
effect is proportional to the pressure
applied on the lever and to the type of
terrain and its snow coverage.