Engine Oil Filter (900 Ace); Oil Filter (1200 4-Tec) - BRP Lynx REV-XU Series Operator's Manual

Engine Oil Filter (900 ACE)

Engine Oil Filter Replacement
Oil Filter Removal
1. Remove the RH side panel.
2. Clean oil filter area.
3. Remove:
– Oil filter cover screws
– Oil filter cover with O-ring
– Oil filter.
mmr2011-070-007_a
1. Oil filter cover screws
2. Oil filter cover
3. O-ring (discard)
4. Oil filter
4. Dispose filter as per your local envi-
ronmental regulations.
Oil Filter Installation
1. Check the oil filter inlet and outlet
orifices inside oil filter receptacle
(integrated part of magneto cover)
for dirt and contaminations.
mmr2011-070-008_a
1. Oil inlet orifice from the oil pressure pump
2. Oil outlet orifice to the engine lubrication
system
3. Oil filter receptacle
2. Install a NEW O-ring on oil filter
cover.
3. Install the new filter into the cover.
4. Lubricate filter seal and cover O-ring
with engine oil.
mmr2011-070-009_a
1. Lubricate with engine oil
5. Install the oil filter cover.
6. Tighten oil filter cover screws to
specification.
TIGHTENING TORQUE
Oil Filter
Cover
7. Wipe off any oil spillage on engine.

Oil Filter (1200 4-TEC)

Oil Filter Removal
1. Remove the RH side panel.
2. Remove muffler, refer to
SYSTEM
______________
MAINTENANCE PROCEDURES
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
EXHAUST
.
107