Engine Oil Replacement (900 Ace) - BRP Lynx REV-XU Series Operator's Manual

MAINTENANCE PROCEDURES
2. Let engine run at idle for 30 more
seconds.
3. Stop engine.
4. Open the LH side panel, refer to
CONTROLS, INSTRUMENTS AND
EQUIPMENT
.
5. Remove the drive belt guard, refer
DRIVE BELT GUARD
to
6. Remove dipstick from the filler tube,
then wipe it clean.
7. Completely insert dipstick in the
filler tube.
8. Remove dipstick and check the oil
level. Oil level should be between
the MIN and MAX marks as shown,
add if necessary.
mmo2009-005-027_a
1. Oil level between MIN. and MAX.
CAUTION Engine oil can be
very hot.
WARNING
Wipe off any oil spills. Oil is highly
flammable when heated.
Engine Oil Replacement
(900 ACE)
CAUTION The engine oil can
be very hot. Wait until engine oil is
warm.
______________
104
.
MAX.
1
MIN.
NOTICE
Engine oil and oil filter
must be replaced at the same time.
1. Bring engine to its normal operating
temperature.
2. Place vehicle on a level surface.
3. Remove the LH side panel.
4. Remove dipstick.
mmo2014-004-011_a
LH SIDE OF VEHICLE
1. Oil tank dipstick
OIL FILTER
5. Remove
in this subsection.
6. From underneath the vehicle, ac-
cess the drain plug:
6.1 Remove one access cover re-
taining screw and loosen the
other.
6.2 Pivot the access cover to clear
the bottom pan opening.
fmo2016-003-012_a
1. Drain plugs access cover
, see procedure