Lights - BRP Lynx REV-XU Series Operator's Manual

WARNING
Do not use a higher rated fuse.
WARNING
If fuse has burnt out, source of mal-
function should be determined
and corrected before restarting.
See an authorized Lynx dealer for
servicing.
Fuse Box Location
The fuse box is located behind the front
seat upholstery at the LH front lower
portion of seat.
To access the fuse box:
– Open the LH lower side panel
– Carefully pull seat upholstery out of
the aluminum extrusion by pulling
the plastic strip downwards and
sideways at the same time
mmo2009-004-036_b
TYPICAL - PULL STRIP
mmo2009-004-037_a
1. Fuse box
To close upholstery, push the strip back
in the aluminium extrusion.

Lights

Always check light operation after bulb
replacement.
Headlights Bulb Replacement
NOTICE
of an halogen bulb with bare fingers,
it shortens its operating life. If glass
is touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
1. By using a small screwdriver, re-
lease multifunction gauge locking
tabs.
mmo2007-009-061_a
1. Locking tab
2. Gently pull on multifunction gauge
and set aside.
mmo2007-009-062_a
3. Unplug burnt bulb connector. Re-
move the rubber boot.
______________
MAINTENANCE PROCEDURES
Never touch glass portion
123