Throttle Lever; Brake Lever; Parking Brake Lever - BRP Lynx Commander 800R E-TEC 2018 Operator's Manual

2) Throttle Lever

Throttle Lever
Throttle lever is located on the RH side
of handlebar.
Designed to be thumb activated.
When squeezed, it increases the en-
gine speed. When released, engine
speed returns automatically to idle.
mmo2008-008-011_b
TYPICAL
1. Throttle lever
2. To accelerate
3. To decelerate
WARNING
Test the throttle lever operation
each time before starting the en-
gine. The lever must return to its
the rest position once released.
Otherwise, do not start engine.

3) Brake Lever

Brake lever is located on the LH side of
handlebar.
When squeezed, the brake is applied.
When released, it automatically re-
turns to its the rest position. Braking
effect is proportional to the pressure
applied on the lever and to the type of
terrain and its snow coverage.
CONTROLS, INSTRUMENTS AND STANDARD EQUIPMENT
mmo2014-004-001_a
TYPICAL
1. Brake lever
2. To apply brake

4) Parking Brake Lever

Parking brake lever is located on the LH
side of handlebar.
Parking brake should be used when-
ever snowmobile is parked.
mmo2014-004-001_b
TYPICAL
1. Parking brake lever
Make sure parking brake is fully
disengaged before operating the
snowmobile. When you ride the
vehicle, brake pads that are caused
to drag by a continuous pressure
on the lever may cause damage to
the brake system and cause loss of
braking capacity and/or fire.
To Engage Parking Brake
Apply and hold brake, then lock brake
lever using the parking brake lever as
shown.
_______________
WARNING
29