Seat Heater (If Equipped); Eco/Standard/Sport Mode Switch (900 Ace And 1200 4-Tec); Hill Brake Switches (If Equipped); Hill Brake (If Equipped) - BRP Lynx REV-XU Series Operator's Manual

CONTROLS, INSTRUMENTS AND EQUIPMENT
fmo2016-002-003_c
1. ECS², module
REAR SUSPENSION ADJUST-
Refer to
MENT TUNE YOUR RIDE
in the
tion
37) Seat heater (If
Equipped)
Seat heater switch is installed at front,
near gearshift lever.
Seat heater can be switched ON or
OFF.
fmo2014-003-005_a
1. Seat heater switch
2. Heat OFF
3. Heat ON
38) ECO/Standard/Sport
Mode Switch (900 ACE
and 1200 4-TEC)
The Mode switch is located on the LH
side of fuel tank.
______________
72
mmo2015-008-002_a
TYPICAL - LH SIDE OF FUEL TANK
1. Mode switch
sec-
It is used to activate or deactivate
Eco/Standard/Sport modes.
Refer to
tails.
39) Hill Brake Switches (If
Equipped)
Hill brake and Hill brake switches are
sold as accessories.
Hill Brake Switches are located on the
LH side of handlebar.
fmo2013-006-011_a
1. Hill Brake up
2. Hill Brake down

40) Hill Brake (If Equipped)

Hill brake for safe stopping on steep
slopes.
41) Accessory Control
Switches (If Equipped)
The accessory control switches are lo-
cated on the console.
OPERATING MODES
for de-