Adjustable Handlebar (If Equipped); Track; Fuses; Anchor Points (If Equipped) - BRP Lynx REV-XU Series Operator's Manual

CONTROLS, INSTRUMENTS AND EQUIPMENT
22) Adjustable Handlebar
(If Equipped)
The handlebar height is adjustable. To
adjust, proceed as follows:
1. Pull up the lock lever.
fmo2015-003-006_a
1. Lock lever
2. Bring the handlebar to the desired
position and push down the lock
lever to lock it.
NOTE: On the other models, the steer-
ing can be set to a desired fixed posi-
tion, see your Lynx authorized dealer.

23) Track

WARNING
Never stud a track that has not
been approved for studs.
stalling studs on an unapproved
track could increase the risk of the
track tearing or severing, possibly
resulting in serious injury or death.
Before proceeding with the installation
of special studs on tracks you must
contact your authorized LYNX snow-
mobile dealer for current specific stud-
ding availability and applications.
BRP does not recommend to ride a
snowmobile equipped with high lug
profile track at high speed in a trail, on
hard packed surfaces or ice for an ex-
tended period of time.
In the event that you have to, reduce
your speed, then minimize the dis-
tance you ride on those surfaces.
______________
66
CAUTION Running
tracks at high speed in a trail, on
hard packed surfaces or ice put more
stress on the lugs, which tend to
heat up as a result. To avoid poten-
tial degradation or damage to the
track, reduce your speed, then mini-
mize the distance you ride on those
surfaces.
For general instructions on mainte-
nance of tracks, refer to the sections
TRACK
and
ALIGNMENT
section of this guide.

24) Fuses

The electrical system is protected with
fuses, refer to
MAINTENANCE PROCEDURES
in
details.
25) Anchor Points (If
Equipped)
In-
mmo2012-009-001_a
REAR OF VEHICLE
1. Anchor points
Two anchor points are provided to se-
cure load in rear rack.
NOTICE
load capacity of rear rack. MAXI-
MUM cargo load is 30 kg (66 lb).
TRACK TENSION AND
MAINTENANCE
in the
FUSES AND RELAYS
Do not exceed maximum
those
for