Drive Belt - BRP Lynx REV-XU Series Operator's Manual

MAINTENANCE PROCEDURES
5. Wait a while to allow all oil to drain
out of gearbox.
6. Install drain plug and tighten to spec-
ification.
TIGHTENING TORQUE
Gearbox drain plug
Gearbox Oil Filling
NOTE: Vehicle must be on a level sur-
face.
1. Remove the filler cap.
2. Remove oil level check plug.
619900950-002_a
1. Filler cap
mmo2009-004-033_a
1. Check plug
3. Pour recommended oil into gearbox
through the filler hole.
NOTE: Oil level is correct when it just
begins to come out of the check plug
orifice.
______________
112
8 N•m (71 lbf•in)
4. Reinstall check plug and tighten to
specification.
TIGHTENING TORQUE
Oil level check
plug

Drive Belt

Drive Belt Inspection
Inspect belt for cracks, fraying or ab-
normal wear (uneven wear, wear on
one side, missing cogs, cracked fab-
ric). If abnormal wear is noted, prob-
able cause could be pulley misalign-
ment, excessive RPM with frozen
track, fast starts without warm-up pe-
riod, burred or rusty sheave, oil on belt
or distorted spare belt. Contact an au-
thorized Lynx dealer.
Spare Drive Belt
A spare drive belt can be stored in the
storage box.
NOTE: Spare drive belt is not supplied
with the snowmobile (Spare drive belt
is supplied with Commander Limited).
CAUTION To avoid damages
to the drive belt, ensure that things
which are carried in storage box are
not damaged the spare drive belt.
Drive Belt Replacement
Drive Belt Removal
1. Remove tether cord cap from en-
gine cut-off switch.
2. Open LH side panel, refer to
TROLS, INSTRUMENTS
EQUIPMENT
in this section.
3. Remove belt guard, refer to
GUARD REMOVAL
4. Insert the driven pulley expander
provided in the tool kit in the
threaded hole on the adjuster hub
as shown.
10 N•m (89 lbf•in)
CON-
AND
BELT
.