BRP Lynx REV-XU Series Operator's Manual page 121

MAINTENANCE PROCEDURES
mmr2009-133-001_a
mmr2009-133-002_a
1. Deflection O-ring aligned with slider shoe
10. Load reading must be as per the following table.
TRACK DEFLECTION
SETTING
TRACK LOAD READING
11. If load reading is not in accordance
with the specification, adjust track
tension. Refer to
SION ADJUSTMENT
NOTICE
Too much tension will
result in power loss and excessive
stress on suspension components.
Track Tension Adjustment
1. Remove the tether cord cap from
engine cut-off switch.
2. Remove rear wheel caps (if so
equipped).
______________
118
TRACK ADJUSTMENT SPECIFICATION
MODELS WITH
EASYRIDE
SUSPENSION
ALL OTHER MODELS
ALL MODELS
TRACK TEN-
.
9. Read load recorded by the upper
O-ring on the tensiometer.
mmr2009-133-003_a
LOAD READING
1. Upper O-ring
40 mm to 45 mm
(1.575 in to 1.772 in)
40 mm to 50 mm
619900696-007
EASYRIDE SUSPENSION
(1.5 in to 2 in)
7.3 kgf (16 lbf)