Spark Plugs; Engine Stopper (E-Tec Models) - BRP Lynx REV-XU Series Operator's Manual

Spark Plugs

Spark plugs inspection or replacement
may be performed by an authorized
Lynx dealer, repair shop, or person of
your own choosing. Spark plugs in-
spection or replacement requires an
in-depth technical knowledge. Though
not required, it is recommended that
an authorized Lynx dealer performs
spark plugs inspection or replacement.
Engine Stopper (E-TEC
models)
Engine Stopper Adjustment
The engine stopper is located on the
LH front engine support, in front of the
drive pulley.
1. Remove tether cord cap from en-
gine cut-off switch.
2. Remove the LH lower side panel, re-
CONTROLS, INSTRUMENTS
fer to
AND EQUIPMENT
3. Remove drive belt guard, refer to
DRIVE BELT GUARD REMOVAL
4. Loosen the three screws retaining
the engine stopper to the engine
support just enough to allow a verti-
cal play (1/2 to one turn).
mmo2010-009-007_a
1. Drive pulley
2. Engine stopper screws
3. Engine stopper
5. Insert a 0.5 mm (.02 in) feeler gauge
in the engine stopper opening (see
illustration).
.
.
______________
MAINTENANCE PROCEDURES
mmo2010-009-001_a
1. Opening
2. Feeler gauge
6. Place feeler gauge between engine
stopper and rubber stop block (on
engine).
NOTE: Do not insert the feeler gauge
too deep, as it will pass over the bump
at the surface of the rubber stop block
and alter adjustment. See illustration.
mmo2010-009-002_a
1. Rubber stop block
2. Bump
3. Feeler gauge
7. Tighten screws to specification, fol-
lowing the illustrated sequence.
Take care not to pinch the feeler
gauge.
109