Recommended Oil; Injection Oil Level Verification - BRP Lynx REV-XU Series Operator's Manual

WARNING
– Always stop engine before refu-
eling. Open cap slowly.
– If a differential pressure condi-
tion is noticed (whistling sound
heard when loosening fuel tank
cap) have vehicle inspected
and/or repaired before further
operation.
– Fuel is flammable and explosive
under certain conditions.
– Never use an open flame to
check fuel level.
– Never smoke or allow flame or
spark in vicinity.
– Always work in a well-ventilated
area.
– Never top up the fuel tank be-
fore placing the vehicle in a
warm area. As temperature in-
creases, fuel expands and may
overflow.
– Always wipe
spillage from the vehicle.
NOTE: Do not sit or lean on seat when
fuel tank cap is not properly installed.

Recommended Oil

600 HO E-TEC and 800R E-TEC
ENGINE
600 HO E-TEC
800R E-TEC
All other countries:
off any fuel
RECOMMENDED
INJECTION OIL
2T
Scandinavia:
E-TEC SYNTHETIC
OIL (EUR)
(P/N 779281)
2T
E-TEC SYNTHETIC
OIL (P/N 779126)
_______________
NOTICE
The engine of this snow-
mobile has been developed and
validated using the recommended
BRP XPS™ oil. BRP recommends
the use of its recommended XPS
oil which is specifically blended for
its engine operation characteristics.
Or a two stroke lubricant designed
for snowmobiles meeting the fol-
lowing lubricant industry specifica-
tions: 1) JASO FD (M345-2004) and
2) SAE Grade 4 (F/M 4). These spec-
ifications are a minimum but do not
guarantee trouble free operation.
Damages caused by oil which is not
suitable for this oil injected 2-stroke
engine may not be covered by the
BRP limited warranty.
1200 4-TEC and 900 ACE
ENGINE
Scandinavia:
(EUR) (P/N 779286)
1200 4-TEC
900 ACE
All other countries:
0W40 SYNTHETIC OIL
NOTICE
The engine of this snow-
mobile has been developed and val-
idated using the BRP XPS™ oil. BRP
recommends the use of its XPS oil or
equivalent. Damages caused by oil
which is not suitable for this 4-stroke
engine may not be covered by the
BRP limited warranty.
If the recommended oil is not avail-
able, use SAE 0W-40 synthetic-based
oil that meets or exceeds the require-
ments for API service classification
SM.
Injection Oil Level
Verification
The injection oil reservoir is located
behind the RH side panel. See
TROLS, INSTRUMENTS AND EQUIP-
MENT
for opening procedure.
FUEL AND OIL
RECOMMENDED
ENGINE OIL
4T 0W40
SYNTHETIC OIL
4T
(P/N 779139)
CON-
75